ISOLATION OF CRYSTALLITE ANATASE AND RUTILE FROM TiO2 P25 FOR DYE SENSITIZED SOLAR CELL
The isolation of crystallite anatase and rutile from commercial TiO2 P25 Degussa was carried out. The aim of this research was to study the potential of pure anatase and rutile based Dye Sensitized Solar Cell (DSSC) for the development of industrial DSSC. The crystal phase, crystal size and crystal...
Saved in:
| Main Authors: | , |
|---|---|
| 格式: | Theses and Dissertations NonPeerReviewed |
| 出版: |
[Yogyakarta] : Universitas Gadjah Mada
2014
|
| 主題: | |
| 在線閱讀: | https://repository.ugm.ac.id/133330/ http://etd.ugm.ac.id/index.php?mod=penelitian_detail&sub=PenelitianDetail&act=view&typ=html&buku_id=73933 |
| 標簽: |
添加標簽
沒有標簽, 成為第一個標記此記錄!
|
| 總結: | The isolation of crystallite anatase and rutile from commercial TiO2 P25
Degussa was carried out. The aim of this research was to study the potential of
pure anatase and rutile based Dye Sensitized Solar Cell (DSSC) for the
development of industrial DSSC. The crystal phase, crystal size and crystal shape
of TiO2 P25, isolated anatase and isolated rutile were characterized by X-ray
Diffraction (XRD) and Transmission Electron Microscopy (TEM). DSSC
parameters including Fill Factor (FF), Current Short Density (Jsc) and Open
Voltage (Voc) were determined to calculate the cell efficiency from I-V test using
ruthenium-N719 sensitized cell test.
Crystallite Anatase was isolated by dissolving TiO2 P25 powder in ammonia
and hydrogen peroxide solution for 15 hours followed by washing and drying.
Whereas the isolation of rutile was done by dissolving P25 in hydrofluoric acid
solution for 24 hours followed by washing and drying. DSSC cell performances of
the isolated anatase, isolated rutile and original P25 photoanodes were measured.
The I-V curves were measured under 100 mW /cm2 Xe lamp with active area of
1.5 cm2.
Pure anatase and rutile were successfully isolated with the percent yield of
35% and 25.6% respectively. X-ray diffraction pattern showed obviously that no
rutile contaminant in the resulted anatase and vice versa. TEM image shows
characteristic crystallite anatase and crystallite rutile with the particle size of 21
nm and 40 nm. Surface area measurement exhibits that surface area of isolated
anatase was 64.7m2/g slightly higher than that of P25. Whereas, surface area of
isolated rutile was 33.17m2/g slightly lower than that of P25. Study of crystal
transformation of anatase to rutile showed that isolated anatase is more stable than
that of P25. The evaluation of DSSC performance shows that the DSSC efficiency
of anatase (0.79%) and rutile (0.55%) based cell are higher than that of P25
(0.51%) based cell |
|---|