Software release time determination based on unbounded NHPP model

由 Xie, M., Hong, G.Y.
出版 2014

A study of the sensitivity of software release time

由 Xie, M., Hong, G.Y.
出版 2014

Development of the exercise self-efficacy scale for Chinese older adults

由 Hong G., Panuthai S., Srisuphan W., Wannarit T.
出版 2014

Multi-category micro-milling tool wear monitoring with continuous hidden Markov models

由 Zhu, K., Wong, Y.S., Hong, G.S.
出版 2014

Flank wear measurement by successive image analysis

由 Wang, W., Wong, Y.S., Hong, G.S.
出版 2014

Adaptive-VDHMM for prognostics in tool condition monitoring

由 Yue W, Wong Y.S, Hong G.S
出版 2016

Integral Sliding Mode Control for Fast Tool Servo diamond turning of micro-structured surfaces

由 Yu, P., Hong, G.S., Wong, Y.S.
出版 2014

A new tool life criterion for tool condition monitoring using a neural network

由 Zhou, Q., Hong, G.S., Rahman, M.
出版 2014

Using neural network for tool condition monitoring based on wavelet decomposition

由 Hong, G.S., Rahman, M., Zhou, Q.
出版 2014

On-line cutting state recognition in turning Using a neural network

由 Rahman, M., Zhou, Q., Hong, G.S.
出版 2014

HMM with explicit state duration for prognostics in face milling

由 Yue, W., Hong, G.S., Wong, Y.S.
出版 2014

Six Sigma in software quality

由 Hong, G.Y., Goh, T.N.
出版 2014

Sequential independent component analysis for cutting forces de-noising in micro-machining tool condition monitoring

由 Zhu, K., Hong, G.S., Wong, Y.S.
出版 2014

Application of Kohonen neural network for tool condition monitoring

由 Rahman, M., Zhou, Q., Hong, G.S.
出版 2014

Direct neural control system: Nonlinear extension of adaptive control

由 Yuan, M., Poo, A.N., Hong, G.S.
出版 2014

Design of series damper actuator

由 Zhou, W., Chew, C.-M., Hong, G.-S.
出版 2014

Analysis of operator's behavior in manual tracking systems

由 Low, K.B., Subramaniam, V., Hong, G.S.
出版 2014

Wavelet analysis of sensor signals for tool condition monitoring: A review and some new results

由 Zhu, K.P., Wong, Y.S., Hong, G.S.
出版 2014

Optimal selection of machining parameters for fast tool servo diamond turning

由 Yu, D.P., Wong, Y.S., Hong, G.S.
出版 2014

A novel method for determination of the subsurface damage depth in diamond turning of brittle materials

由 Yu, D.P., Wong, Y.S., Hong, G.S.
出版 2014